Mounting set for support handle, Black cover button

This mounting kit is compatible with support handle item no. 250561 (see accessories)

The kit includes the following components:

1. 4 Fischer nylon plugs, Ø 10 x 60 mm
2. 4 hex head screws DIN 571 A2, 8 x 80 mm
3. 4 stainless steel washers DIN 125
4. 4 black Cover caps nv 13

Installation Instructions for Wall Support Bar:

1. Position the wall support bar at the desired spot on the wall. Mark the screw holes using a pencil through the mounting holes.
2. Drill four holes of Ø 10 mm, at least 80 mm deep, into the wall. Insert the nylon plug (A) using a hammer. Ensure the plug is secure and undamaged during installation.
3. Place the washers (C) onto the hex screws (B). Fit these through the wall bar’s holes and tighten firmly.
4. Attach the protective Cover cap (D) to each of the four screw heads.

IMPORTANT! Before use, make sure the wall bar does not move, even under heavy load. The installer is responsible for a secure installation and for verifying that the wall type and condition are suitable for mounting with this kit.