XL Bath Cover for Lower Leg - SealProtect®

With a waterproof shower protector, you can take a bath with a cast, bandage, dressing, wound, rash, splint, prosthesis, or anything else that should not get wet.

The shower cover consists of a plastic ring with an internal silicone membrane, which you pull your hand through before placing your arm into the vinyl bag. It's essential that the silicone seal sits above the bandage/cast and fits snugly.

The shower protector measures 57 cm in length and fits legs with extra width, with a maximum circumference of 72 cm / Ø25 cm - including the bandage.

Measure from the tip of the foot to the end of the area that needs protection - cast, bandage, prosthesis, or similar. Add 4 cm to get the correct length for your shower protector. Be mindful of the maximum circumference measurement, including the cast, bandage, or similar.

ONLINE PRODUCT - This item can only be purchased from the webshop and is not available in-store.

How to use your SealProtect shower cover:

1. Hold the plastic ring and create a large opening with your hands, pulling SealProtect as far up as possible. Be careful not to put pressure on the plastic ring when putting on SealProtect.
   
2. Ensure SealProtect sits at least 3 cm above the cast, bandage, splint, or similar for optimal protection.
   
3. Gently push the plastic ring down a bit so that the silicone membrane faces upwards as shown in the last image.

It's important to dry the ring and the rubber membrane before removing SealProtect, as water can collect in the ring where the rubber membrane is situated.

Safety:

• SealProtect can become slippery when wet.
• Use SealProtect with caution.
• Adult supervision is recommended when children use SealProtect.
• Only dry SealProtect with a towel.
• Do not dry SealProtect on a heater.