Shower Cover for Lower Leg - SealProtect®

The bath cover consists of a plastic ring with an inner silicone membrane. You pull your hand through, and then your arm continues into the vinyl bag. It's crucial that the silicone seal is placed over the bandage/cast and fits snugly.

The bath protector measures 61 cm in length and fits forearms with a maximum circumference of 53 cm / Ø18 cm - including bandage.

Measure from the tip of the longest finger to the end of the area to be protected - cast, bandage, prosthesis, or the like. Add 4 cm to obtain the correct length of your bath protector. Pay attention to the maximum circumference measurement, including the cast, bandage, or similar.

How to use your SealProtect bath cover:

1. Hold onto the plastic ring and create a large opening with your hands, pull the SealProtect up as far as possible. Be careful not to put pressure on the plastic ring when putting on the SealProtect.
   
2. Ensure that SealProtect sits at least 3 cm above the cast, bandage, splint, or similar for optimal protection.
   
3. Gently press the plastic ring down a bit so that the silicone membrane turns upwards as shown in the last image.

It's important to dry the ring and the rubber membrane before removing the SealProtect, as water may collect in the ring where the rubber membrane sits.

Safety:

• SealProtect may become slippery when wet.
• Use SealProtect with caution.
• Adult supervision is recommended when children use SealProtect.
• Only dry SealProtect with a towel.
• Do not dry SealProtect on a heater.