Bath Cover for Full Leg - SealProtect®

The bath cover features a plastic ring with an inner silicone membrane that you pull your hand through before sliding your arm into the vinyl bag. It's important that the silicone seal sits over the bandage/cast and fits tightly.

The bath protector measures 102 cm in length and fits a full leg with a maximum circumference of 75 cm / Ø25 cm - including the bandage.

Measure from the tip of the longest finger to the end of the area that needs protection - cast, bandage, prosthetic or similar. Add 4 cm to find the correct length for your bath protector. Be mindful of the maximum circumference measurement including the cast, bandage, or similar.

How to use your SealProtect bath cover:

1. Hold the plastic ring and create a large opening with your hands, pull the SealProtect up as far as possible. Take care not to put pressure on the plastic ring when putting on the SealProtect.
   
2. Ensure that the SealProtect is at least 3 cm above the cast, dressing, splint, or similar for optimal protection.
   
3. Gently push the plastic ring down slightly so the silicone membrane faces upwards, as shown in the last image.

It's important to dry the ring and the rubber membrane before removing the SealProtect, as water may collect in the ring where the rubber membrane sits.

Safety:

• SealProtect can become slippery when wet.
• Use SealProtect with caution.
• Adult supervision is recommended when children use SealProtect.
• Dry SealProtect only with a towel.
• Do not dry SealProtect on a heater.