Shower Cover for Lower Leg - SealProtect®

The cover is constructed with a plastic ring and an internal silicone membrane. Slide your hand through the membrane and then insert your arm into the vinyl sleeve. Make sure the silicone seal sits above the bandage or cast and creates a tight fit.

This bath protector is 61 cm long and fits forearms with a maximum circumference of 53 cm / Ø18 cm, bandage included.

To determine the correct size, measure from the tip of your longest finger to the farthest edge of the area needing protection—whether it’s a cast, bandage, prosthetic, or similar item. Add 4 cm to your measurement for the ideal length. Please also ensure that the total circumference, including any cast or bandage, does not exceed the maximum size.

ONLINE EXCLUSIVE – This product can only be purchased through our webshop and is not available in stores.

How to use your SealProtect bath cover:

1. Grip the plastic ring and use both hands to create a wide opening. Carefully pull the SealProtect up as far as possible without putting pressure on the plastic ring as you put it on.
   
2. Make sure SealProtect sits at least 3 cm above your cast, bandage, splint, or similar to ensure full protection.
   
3. Gently press the plastic ring downward so the silicone membrane sits upward, as shown in the final image.

For best results, dry the ring and rubber membrane before removing SealProtect, as water may collect in the ring where the membrane meets the plastic.

Safety information:

• SealProtect can become slippery when wet.
• Use SealProtect with care.
• Children should use SealProtect only under adult supervision.
• Always dry SealProtect with a towel.
• Do not dry SealProtect on a radiator or heater.